2PCS 6.5" Cloth Speaker Cone 155mm Black – Rubber Surround Recone Repair Part

## 2PCS 6.5" Cloth Cone with Rubber Surround – Recone Repair Parts

This listing is for a pair of 6.5 inch speaker cones: black cloth cone bodies
with the rubber surround already bonded on. Two cones, so you can rebuild both
drivers in a cabinet at the same time and keep the pair matched.

Cloth cones are the sound of a lot of vintage and pro audio drivers – warm in
the mids, controlled breakup up top, and a bit more forgiving than a stiff
paper cone. Paired with a rubber surround, you get long throw and an edge that
won't rot the way foam does.

### Dimensions (each cone)

| Item | Specification |
|---|---|
| Nominal size | 6.5 inch |
| Outside diameter | 155 mm ±2mm |
| Surround inner diameter (cone opening) | 140 mm ±2mm |
| Depth | 32 mm ±2mm |
| Center hole (voice coil hole) | 26 mm ±1mm |
| Cone material | Cloth, black |
| Surround material | Rubber |

*Measure with callipers before ordering. A part that reads 153mm or 157mm is
within spec.*

### Will It Fit Your Speaker?

- **Outside diameter (155mm)** must clear the basket's inner lip and mounting
  holes. If your frame opening is smaller than 155mm, this cone won't drop in.
- **Center hole (26mm)** is the one you can't fix later. Measure your voice
  coil former's outer diameter – it should be a close slip fit, tight enough to
  self-centre while the glue sets.
- **Depth (32mm)** sets how the cone sits in the frame and whether the dust
  cap clears the pole piece.
- **Both cones in this pack share the same batch**, so the pair will match.

### Fitting Notes

1. Remove the old cone and clean the frame and voice coil former.
2. Dry-fit the new cone and check the coil centres in the gap without rubbing.
3. Apply a thin, even bead of adhesive at the rubber-to-frame edge and around
   the coil former at the centre hole.
4. Let it cure fully before playing any signal.

### FAQ

**How many cones do I get?**
Two. Enough for a stereo pair of 6.5" drivers.

**Does this include voice coils, spiders or dust caps?**
No – cone and rubber surround only. You reuse your existing coils and spiders.

**Is this for 6" or 6.5"?**
It's a 6.5" cone (155mm OD). It may suit some 6" drivers, but only if your
frame opening and 26mm centre hole match. Measure your old cone rather than
going by the nominal size.

**Why cloth instead of paper?**
Cloth is lighter and more damped, so it keeps the midrange smooth and tends to
sound closer to the original driver.

### Package Includes

- 2 × 6.5" black cloth cone with rubber surround