DIYMars
CBB60 20MFD 250V AC Capacitor 2-Wire for Washing Machine Pump Motor
CBB60 20MFD 250V AC Capacitor 2-Wire for Washing Machine Pump Motor
Não foi possível carregar a disponibilidade de recolha
CBB60 20µF 250VAC Motor Start-Run Capacitor – for Washer Pumps
This CBB60 20µF (20MFD) 250VAC capacitor uses metallized polypropylene film in a flame-retardant case with 2-wire leads, built for start-run duty in single-phase AC motors. The go-to replacement for washing machine drain pump motors, small appliance motors, and light commercial pump units running on 220–240V supplies.
Key Features
- ✅ Type: CBB60 metallized polypropylene film capacitor
- ✅ Capacitance: 20µF (20MFD)
- ✅ Rated Voltage: 250V AC
- ✅ Duty: Motor start-run (continuous run with start assist)
- ✅ Leads: 2-wire outlet (tinned copper, non-polarized)
- ✅ Self-healing dielectric – recovers from micro-breakdown
- ✅ Low dissipation factor – runs cool under load
- ✅ Flame-retardant molded case (UL94-V0 class typical)
- ✅ RoHS compliant, no PCB
Specifications
| Parameter | Value |
|---|---|
| Capacitor Type | CBB60 (Metallized Polypropylene Film) |
| Capacitance | 20µF / 20MFD |
| Rated Voltage | 250V AC |
| Tolerance | ±5% (J) typical |
| Duty Class | Motor start-run (per IEC 60252-1 Class B/C) |
| Number of Leads | 2 wires (non-polarized) |
| Dielectric | Metallized polypropylene film |
| Operating Temperature | -40°C to +70°C (some to +85°C) |
| Case Material | Flame-retardant molded plastic |
| Mounting | Screw tab / cable tie bracket (model dependent) |
| Compliance | RoHS, IEC 60252-1 reference |
Applications
- Washing machine drain pump motors
- Washer spin / circulation pump motors
- Small single-phase AC induction motors
- Dishwasher drain pump motors
- Small water pump & fountain pump motors (250V class)
- Compactor / shredder / small appliance motors
CBB60 vs CBB61 – Quick Note
- CBB60: Often used in start-run combined duty for appliance pump motors, slightly different internal winding/standard framing than CBB61.
- CBB61: More common in fan motor pure-run duty.
- Both are metallized PP film, non-polarized, 2-wire. Match the original cap's printed type when possible.
Wiring & Replacement
- Non-polarized: Either wire goes to either motor terminal per the appliance schematic.
- Power off + discharge: Unplug the washer, discharge old cap before touching leads.
- Match values: Replace with 20µF ±5% and 250VAC or higher. Never drop to 110V/125V class.
- Check the symptom: Pump hums but won't spin = classic failed run cap. Swap before condemning the motor.
Why This Cap
A drained washer pump that just buzzes is usually a dead capacitor, not a dead motor. This CBB60 20µF 250VAC unit restores starting torque and run efficiency with low-loss PP film that stays cool through thousands of wash cycles. Self-healing dielectric means minor overstress won't immediately kill it, and the 2-wire lead-out drops straight into the existing spade or twist connector. Stock it as a service-part staple.
Order today – fast worldwide shipping on CBB60 washer pump capacitors.
Partilhar
